This Aluminium PCB is part of a range of 10mm MCPCB’s we offer. It is designed to take a single led and is designed for, Cree XP leds.
Direct Thermal Path : Dielectric under the thermal pad of LED
The MCPCB-XP10-Groove module requires attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers
For optimal cooling, we recommend that the module be mounted to a suitable finned heat sink (aluminium or copper) that is exposed to open air. The module can be mounted to a heat sink in various ways
- Arctic Alumina thermally conductive adhesive
- Thermal Compound: Requires the use of mechanical fasteners
Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.
The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.
Please note the use of Thermal Adhesives makes the PCB unlikely to be removed for servicing. Please consider this if removal of the board is desired as another TIM may be a better choice.
Termination: The PCB has an edge Anode and Cathode pad so wire can be soldered to top pads, close to the board edge
|PCB TYPE||10 mm Round PCB|
|PCB SIZE||10mm x 2.0mm|
|BASE METAL TYPE||Aluminium|
|DIRECT THERMAL PATH||YES|
|THERMAL CONDUCTIVITY||3 W/m.K|
|GLASS TRANSITION TEMP.||170 degree Celsius|
|COMPATIBLE LED||Cree XP/XT/XHP35|