SSK-1840 series: Board specific Part Number is SSK-1840-V5K-98-450
is a 840mm or 3ft board. The board is ideal for the 3ft tent space, low profile and will allow you to fill out a typical 3×3 Tent. The board typically could be run to 75 watts.
The high current capability of the 2835 at 480ma means the led can be driven much harder than typical midpowers and can be configured in lower string voltages. This is a 24V Nominal board so can be matched to more widely available 24V led drivers.
Specifications
General
- 216pc x Cree 2835 HE & 9pc x 3535 footprint power Led
- 24V Nominal operation @ ~3.1A – 75W(see below chart for specifics)
- 840 x 24mm footprint
- Molex Stainless Steel Solder Less connectors
- Board is Aluminium, 840mm L x 24mm W x 1.6mm T(unloaded PCB)
Specifications
Product Specific
SSK-1840-V5K-98-450 version uses Cree HE 2835 in 5000k 98CRI and Cree XPG-3 450nm Royal Blue. This is a pure 5000k with 450nm blended Board, early to mid veg growth.
The board has only a few leds less than a typical quantum board, but being spread out over 3ft will provide high photon flux, matched to a beautiful spread pattern and will allow for growth right to the light without tip burn
PAR MAP
Taken in Mylar lined space using 2pcs 840mm Strips at 75 watts each. 17 inch hang height to sensor
PAR MAP
Taken in Mylar lined space using 2pcs 840mm Strips at 96 watts each. 17 inch hang height to sensor
PAR MAP:
Taken in Mylar lined space using 3 pcs 840mm Strips at 85 watts each. 17 inch hang height to sensor
Drive Characteristics
This is based on the led datasheet specifications and may vary dependent on specific bins and total system performance. The current data listed does not account for driver losses.
Reviews
There are no reviews yet.