Cutter-50Round2016-E890

Cutter-50Round2016-E890 is a round Aluminium PCB is 50.5 mm. It is designed to take 32 leds and is designed for, Cree J series 2016 leds. This PCB was created developed for bollard lighting applications

12Volt Constant voltage with optional resistor.

Direct Thermal Path : Dielectric under the thermal pad of LED

The Cutter-50Round2016 module requires attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers

For optimal cooling, we recommend that the module be mounted to a suitable finned heat sink (aluminium or copper) that is exposed to open air. The module can be mounted to a heat sink in various ways

• Arctic Alumina thermally conductive adhesive
• Thermal Compound: Requires the use of mechanical fasteners

Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.

The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.

Please note the use of Thermal Adhesives makes the PCB unlikely to be removed for servicing. Please consider this if removal of the board is desired as another TIM may be a better choice. 

Termination: The PCB has an edge Anode and Cathode pad so wire can be soldered to top pads, close to the board edge

Datasheet

Board Specifications

Output Specifications