MCPCB-XMLRGBW-45428

Description

MCPCB-XMLRGBW-45428: This Aluminium PCB is very specifically XML RGBW. It is designed to take 6 leds, with 5.0 × 5.0mm base, so will suit Cree XML RGBW,  and other multi die leds with the same base dimensions. The board layout is such that the 6 leds are arranged in a Series arrangement.

*Please check manufacturers data sheets to ensure compatibility with this PCB foot print

Thermal Path

Dielectric under the thermal pad of LED

The MCPCB-XMLRGBW-45428 Linear board requires careful attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers

For optimal cooling, we recommend that the module be mounted to a suitable heat sink (aluminium Flat plate is perfect but total thickness will depend on the total power used) that is exposed to open air. The module can be mounted to a heat sink in various ways

• Pressure sensitive, thermally conductive tape (Recommended)

Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.

The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.

Please note the use of Thermal Adhesives makes the PCB unlikely to be removed for servicing. Please consider this if removal of the board is desired as another TIM may be a better choice. 

Optics Support

The board can fit within Linear optics arrays like the Ledil Linnea series the board is also predrilled to take individual 26.5mm optics and holders from Carclo, Holders with pins will allow for simple alignment and can be secured with a Chemically compliant adhesive.(see Cree Chemical compatible datasheet)

use clips available for the Linnea series

Assembly Guide for Optics: Ledil have a good generic guide on assembly of Leds/Optics, adhesives etc. Download

Termination:

The ends of the PCB of has Anode and Cathode pads. The PCB can be standalone or wired in groups in Series or parallel. The board is designed to be use with connectors and cable harness. Connector is a 10 pin Molex connector. The Led requires 8 pins(4 Cathode/4 Anode) the additional 2 pins are to address the on board 47k NTC, so for led drivers with thermal throttling capability, this will enable greater control of drive current relative to on board temperature.. Please use our 10 way harness to access the leds

Harness10wayRGBW-1.25mm

Specifications