Decription
Board specific Part Number is SSK-1840-PSBG3.0-660 is a 840mm or 3ft board. This version uses Cree Photophyll Select 2835 leds. This removes a high% of the normal red in phosphor converted leds and uses the secondary 660nm power led to drive the red needs of the board.
The board is ideal for the 3ft tent space, low profile and will allow you to fill out a typical 3×3 Tent. Also perfect fit for seedling or cloning racks i.e. 1800mm. The board typically could be run to 75 watts.
The high current capability of the 2835 at 480ma means the led can be driven much harder than typical mid-powers and can be configured in lower string voltages. This is a 24V Nominal board so can be matched to more widely available 24V led drivers.
General Specifications
- 216pc x Cree 2835 HE Photophyll Select & 9pc x 3535 footprint power Led
- 24V Nominal operation @ ~3.1A – 75W(see below chart for specifics)
- 840 x 24mm footprint
- Molex Stainless Steel Solder Less connectors, can accept up to 14AWG
- Board is Aluminium, 840mm L x 24mm W x 1.6mm T(unloaded PCB)
Product Specifications
SSK-1840-V35K-98-660 version uses Cree HE 2835 Photophyll Select. Part Number of the led is JB2835BWT–G–X001A0000–N0000001 and Cree XPG-3 660nm. The ratio is 24:1 of White to Deep Red
The board has only a few leds less than a typical quantum board, but being spread out over 3ft will provide high photon flux, matched to a beautiful spread pattern and will allow for growth right to the light without tip burn
PAR MAP
Taken in Mylar lined space using 2pcs 840mm Strips at 75 watts each. 17 inch hang height to sensor
PAR MAP
Taken in Mylar lined space using 2pcs 840mm Strips at 96 watts each. 17 inch hang height to sensor
PAR MAP:
Taken in Mylar lined space using 3 pcs 840mm Strips at 85 watts each. 17 inch hang height to sensor
Reviews
There are no reviews yet.