MCPCB-XB20QUAD-IAD

This Aluminium PCB is very flexible. It is designed to take 4 leds, with 2.0 × 2.0mmmm base, so will suit Cree XBD, or other leds with the same base dimensions. The board layout is such that the 4 leds can be driven in

• series
• parallel
• individually addressed

Series or Parallel are configured on available pads using zero Ohm resistors.

Direct Thermal Path : Dielectric under the thermal pad of LED

The MCPCB-XB20QUAD-IAD module requires careful attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers

For optimal cooling, we recommend that the module be mounted to a suitable finned heat sink (aluminium or copper) that is exposed to open air. The module can be mounted to a heat sink in various ways

• 20mm pressure sensitive, thermally conductive tape (Recommended)
• Arctic Alumina thermally conductive adhesive
• Thermal Compound: Requires the use of mechanical fasteners

Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.

The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.

Please note the use of Thermal Adhesives makes the PCB unlikely to be removed for servicing. Please consider this if removal of the board is desired as another TIM may be a better choice. 

Assembly Guide for Optics: Ledil have a good generic guide on assembly of Leds/Optics, adhesives etc. Download

Optics Support: The board is drilled to take Ledil Carclo 24mm Optics in the 106xx series and other optics with the same pin footprint

Termination: The PCB has edge slots for mounting. The board has 4 Anode/Cathode pads for full addressability or series/parallel configurations

Specifications