MCPCB-XD_Q-S20-AL

Description

MCPCB-XD_Q-S20-AL. This printed circuit board with Aluminium base has been developed for Cree XD16/XQ and other 1.8mm x 1.8mm, 2 Pad led designs and allows you to quickly create your prototypes of LED modules based on this small platform. With it’s high thermal conductivity of 3 W/mK. This printed circuit board is able to drain the heat of the LED components through the Aluminium base, which is ideal for LED lighting. This Metal Core PCB is manufactured with UL certified Aluminium substrates.

The MCPCB-XD_Q-S20-AL is designed to take a single Led.

Thermal Path :  

Dielectric under the thermal pad of LED

The module requires careful attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers

For optimal cooling, we recommend that the module be mounted to a suitable finned heat sink (aluminium or copper) that is exposed to open air. The module can be mounted to a heat sink in various ways

• 20mm pressure sensitive, thermally conductive tape (Recommended)
• 20mm Mechanical application with Graphite Thermal pads. Optimum Thermal Transfer
• Thermal Compound: Requires the use of mechanical fasteners

Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.

The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.

Optics Support:

The board is drilled to take various Optics suited to star boards, 20mm however it is also predrilled with 8.6mm pitch to suit a wide range of the pinned optics produced by Ledil

Select from all 20mm optics

Click here

Select from all 35mm optics

Click here

Select from all 40mm optics

Click here

Select from all 10-20mm optics

Click here

Select from all 40-80mm optics

Click here

Select from all Linear optics

Click here

Termination:

The board has 2 pads in Cathode and anode to allow for wire clearance in multiple application

* some holders may require modifications to allow wire access to the PCB, Cutter assumes no responsibility for holder modifications

Specifications

Applications