MCPCB-XMLRGBW-38S

Description

MCPCB-XMLRGBW-38S: This Aluminium PCB is very specifically XML RGBW. It is designed to take 1 leds, with 5.0 × 5.0mm base, and will suit Cree XML RGBW,  and other multi die leds with the same base dimensions. The board layout is such that the 1 led can be addressed.

*Please check manufacturers data sheets to ensure compatibility with this PCB foot print

Non Direct Thermal Path

Dielectric under the thermal pad of LED

The MCPCB-XMLRGBW-38S Linear board requires careful attention to mounting and cooling to ensure that the junction temperature of the LED is kept well below the maximum rating as specified in the LED documentation published by Led Manufacturers

For optimal cooling, we recommend that the module be mounted to a suitable heat sink (aluminium Flat plate is perfect but total thickness will depend on the total power used) that is exposed to open air. The module can be mounted to a heat sink in various ways

• Pressure sensitive, thermally conductive tape (Recommended)

Before fastening the module to the heat sink, ensure that the two mating surfaces are perfectly flat and clean in order to maximise heat transfer to the the sink.

The bottom of the LED MCPCB is electrically neutral, so it is not necessary to electrically isolate the base from the cooling surface.

Please note the use of Thermal Adhesives makes the PCB unlikely to be removed for servicing. Please consider this if removal of the board is desired as another TIM may be a better choice. 

Optics Support

The board is predrilled with holes to suit  Carclo 20 amd 26.5mm optics when used with Pinned holders and can be secured with a Chemically compliant adhesive.(see Cree Chemical compatible datasheet)

Select from all 20mm optics

Click here

Select from all 35mm optics

Click here

Select from all 40mm optics

Click here

Select from all 10-20mm optics

Click here

Select from all 40-80mm optics

Click here

Select from all Linear optics

Click here

Assembly Guide for Optics

Ledil have a good generic guide on assembly of Leds/Optics, adhesives etc. Download

Termination

The PCB can be standalone or wired in groups in Series or parallel. The board is designed to be use with connectors and cable harness. Connector is a 10 pin Molex connector. The Led requires 8 pins(4 Cathode/4 Anode) the additional 2 pins are to address the on board 47k NTC, so for led drivers with thermal throttling capability, this will enable greater control of drive current relative to on board temperature.

Specifications