Very simple way to connect two sections of wire without having to solder.
- Insert your wires into the connector and use up to three screw terminals to fasten the wire/power cord in place.
- Draw the two Threaded end caps into centre body of the connector
- Screw in to fasten and create a waterproof seal
Each end can accept a max 17AWG wire
Please note that you will need to make sure you are using the correct terminals on each side of the connector (ie. the top terminal on the left side is connected to the top terminal on the right side, the middle connector on the left side is connected to the middle connector on the right side, and the bottom connector on the left side is connected to the bottom connector on the right side). Failure to use this item correctly can lead to damaged drivers, cause a fire hazard, etc and we are NOT responsible for incorrect use of this item. If your unsure we recommend the use of a qualified electrician.
Reviews
There are no reviews yet.